In order to get high performance, the world famous elements have been used on our machine.

Mold clamping cylinder: Festo ( Germany )

High pressure blowing valve: Barket

Low pressure valve: Bosch £¨ Germany £©

Transducer: MITSUBISHI( Japan )

Fully actions controlled by Mitsubishi computer.

Mitsubishi programmable controller can be set up different programs according to the specific bottle. There is a crystal screen and soft buttons, you can see the information clearly and operate it easily.

Through the controller, you can set the time of mold closing, mouth sealing, stretching, blowing and mold opening, there are two operation types-manual and automatic. During the test running, you can set it as manual type, then do the operation step by step; and during the mass production, you can set it as automatic type, the machine will repeat the cycle according to the set parameters.

Running with high precision, stable and quiet.

Our mold platen is made of cast iron, to ensure the running precision of the platen, the surface and guiding hole have been tooling by numerical equipment.

For the guide bar, except the high precision tooling, furthermore we will plate the chrome onto the surface, this is to enhance the strength and the wear-resistant.

In order to blow the different volume bottles on the same machine, we designed a chain-wheel adjusting system on the rear mold platen, you can adjust the distance between the frontal platen and the rear platen through such chain-wheel system, thereby adapt to different mold thickness.

At the same time, also we designed the adjusting system on the fixing plate that is used for installing the sealing-stretch cylinder, through which you can adjust the cylinder forwardly or backwardly, accordingly to ensure the stretch bar on the center of the cavity.

The infrared radiated heating have been adopted to heat the preforms.

We equipped a numerical voltage controller with crystal screen, through which you can adjust the power of the lamps, accordingly to get suitable heating effect for preform's upper part, middle part and bottom part. In addition, there are the temperature detectors on the heating channel, you can see the real temperature from the feedback.

In order to reduce the heating air's bad effect on the preform, we equipped two exhaust fans on the top of the machine to exhaust the heating air. So the heating system is more stable, and the production will be more smooth.